GYS AIRFIX DRAW ALIGNER Mode D'emploi page 12

Operating manual
INSTALLATION AND INSPECTION CHECKS
REGULAR INSPECTION:
- Check that the screws are correctly tightened as described in the «assembly» section.
- Check that the foam gasket and pads are correctly positioned and undamaged.
- Check that the cord is correctly wound on the winch, and that it is not damaged.
If in doubt and/or if a defect is found, do not use the machine and contact the distributor or the manufacturer via the
After Sales Service.
INSTALLATION:
To ensure maximum adhesion to the floor, it is essential to position the Airfix Draw Aligner in a clean area (free of dust
liquids or other contaminants) with no cracks or joints between the tiles to ensure maximum vacuum performance.
The Airfix Draw Aligner is fitted with two rear wheels, tilt the column taking care not to damage the seal which is
located on the underside of the plate.
The Airfix Draw Aligner works with compressed air, the recommended pressure is between 5 and 8 bar.
USAGE:
- Move the pillar by tilting it backwards to the chosen work area.
- Position the Airfix Draw Aligner at an appropriate pulling distance, judged by the operator, as close as possible to the
point being repaired.
- Connect the compressed air hose. Check that the Airfix Draw Aligner is firmly anchored to the ground by pushing it
firmly.
If the column does not stay in position, check the placement of the seal and the condition of the floor,
and repeat the previous operation.
Adjust the winch position to the desired working level. To do this:
- Raise the safety pin at the rear of the winch stand, and tilt the front of the mount upwards.
- Lower or raise the winch while keeping the safety pin raised and the bracket tilted to the desired working po-
sition. Please ensure that the notch is correctly located in the opening in the column.
Make sure that the column is correctly aligned with the panel being straightened.
- The pulling force produced by the winch is 350Kg and is delivered by a mechanical system with an automatic
load brake.
- To release the tension, simply turn the crank in the other direction. To make a downward pull, use the pulley
on the front of the Airfix and pass the cable underneath.
Always keep a minimum of 3 wraps around the winch spool.
12
Translation of the original
instructions
Place the trolley with the winch on the column.
AIRFIX DRAW ALIGNER