GYS AIRFIX DRAW ALIGNER Mode D'emploi page 11

Operating manual
Translation of the original
instructions
ASSEMBLY
Screw the left and right brackets to the base of the co-
lumn using an H8 spanner.
Be careful to position the column with the
notches on the right side, see image.
Screw the column / brackets assembly to the plate using
an H8 spanner.
Screw the wheel supports to the plate using an H8 span-
ner.
Be sure to use the two short M10x12 screws
from the bag with the wheel supports.
Screw the wheels and their axles to the wheel brackets
using an H8 spanner.
Screw the pulley to the bracket using two 19mm span-
ners.
Attach the winch to the bracket using the reinforcement
plate and the 3 bolts. Use an H5 spanner.
AIRFIX DRAW ALIGNER
Screw M10x25: 8
Washer M10: 8
Screw M10x18: 6
Washer M10: 6
Screw M10x12 : 2
Washer M10: 2
Screw M10x18: 4
Washer M10: 4
Screw M12x85: 1
Washer M12: 2
Nut M12: 1
Screw M6x18: 3
Nut M6: 3
11