GE Lumination IS Serie Guide D'installation page 4

4
For 347V fixture: Loosen PSU cover
screws and remove two covers.
Dimming line
(optional)
7
Optional dimmer: Install UL listed
electrical fitting and insert dimming
control wires through. Connect
dimming control wires (grey and violet
for 0-10V or violet and violet/white strip
for DALI) to the similarly colored fixture
wire using separate UL listed wire nuts.
10 Replace power supply cover(s) by
sliding over the captive screws and
secure by tightening them.
Note: When installation is complete,
all lead wires and connectors shall
be totally enclosed.
AC line
5
Carefully remove appropriate knockout
for AC line input wires (inner knockout
for ½" conduit, outer knockout for
¾" conduit). Install listed electrical
fittings in the knockout holes for wire
protection and pass supply conduit
through electrical fittings.
Dimming
wires
8
Clip luminaire to the previously
installed mounting brackets.
Wiring Diagrams
DALI
Fixture
Line
Neutral
Ground
DALI
DALI
0-10V
Fixture
Black Line Black
White Neutral White
Green Ground Green
Violet/White (0-10V) + Violet
Violet (0-10V) – Grey
4
AC line
6
Connect the green (ground), black
(line) and white (neutral) wires of
the AC line to the similarly colored
wires of the power supply unit using
separate UL listed wire nuts.
9
Fix the mounting position and secure
the suspension by tightening the two
screws on both mounting brackets.
PSU
wires