Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Retrofit Solutions
High Lumen Biax Type A
LED Replacement Lamp
LED172G11/830
LED172G11/835
LED172G11/840
LED172G11/850
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save these instructions
These instructions do not purport to cover all details or variations in components nor to provide for every possible contingency to be met with respect
to installation, operation or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently
for the purchaser's purpose, the matter should be referred to Current. Current does not claim liability for any installation not performed according to this
guide or not by a qualified electrician.
For Your Safety
Read and observe all CAUTIONS and WARNINGS shown throughout these instructions.
• Installation to be performed by trained or qualified personnel. Ensure this manual is provided to the installers and users.
• Use this product only in the manner intended by the manufacturer. If there are any questions or concerns, contact the manufacturer.
• The product is designed for indoor application only, and should not be used in environment of high temperature and high humidity.
• The product is not intended for use with Emergency lighting.
• Suitable for dry/damp locations.
RISK OF FIRE OR ELECTRIC SHOCK
• Disconnect power before installation or maintenance. Contact a qualified electrician for installation if needed.
• This lamp only operates on electronic ballasts. If the lamp does not light when the luminaire is energized,
remove lamp from luminaire and contact lamp manufacturer or qualified electrician.
• Suitable for Damp locations.
RISK OF FIRE
• If the lamp or luminaire exhibits undesirable operation (buzzing, flickering, etc.). immediately turn off power,
remove lamp from luminaire and contact manufacturer.
• Do not install this lamp in a pre-heat luminaire.
• Direct replacement for 40W/22TS/T/2Gll/RS lamps only.
• Use only in place of fluorescent lamps specified on label.
WARNING
CAUTION
Installation Guide
LEDL094 | A-1028168
Publicité
Manuels Connexes pour GE Current LED172G11/830
Sommaire des Matières pour GE Current LED172G11/830
- Page 1 Installation Guide LEDL094 | A-1028168 Retrofit Solutions High Lumen Biax Type A LED Replacement Lamp LED172G11/830 LED172G11/835 LED172G11/840 LED172G11/850 BEFORE YOU BEGIN Read these instructions completely and carefully. Save these instructions These instructions do not purport to cover all details or variations in components nor to provide for every possible contingency to be met with respect to installation, operation or maintenance.
- Page 2 0.45-30 MHz. www.gecurrent.com © 2020 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the General Electric Company and are used under license. Information provided is subject to change without notice.
- Page 3 Guide d’installation LEDL094 | A-1028168 Solutions d’adaptation Lampe de remplacement à DEL, à haute luminosité, de type A, Biax LED172G11/830 LED172G11/835 LED172G11/840 LED172G11/850 AVANT DE COMMENCER Lisez attentivement toutes ces instructions. Veuillez conserver ces instructions Ces instructions ne prétendent pas couvrir tous les détails ou les variations des composants ni parer à toute éventualité en rapport avec l’installation, le fonctionnement ou l’entretien.
- Page 4 © 2020 Current Lighting Solutions, LLC. Tous les droits sont réservés. GE et le monogramme GE sont des marques de commerce de General Electric Company et sont utilisés sous licence. Les informations fournies peuvent être modifiées sans préavis. Toutes les valeurs sont des valeurs de conception ou typiques lorsqu’elles sont mesurées dans des conditions de laboratoire.