Télécharger Imprimer la page

GE Lumination IS Serie Guide D'installation page 3

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT - Maximum Length of Electrical Run
IS of First Generation
Lumen Code
Voltage
A E,G,S or J
120V
192'
277V or 347V
400'
• Please see technical data sheet for electrical properties
to ensure safe installation.
• Under any circumstance, maximum driver current
through connected fixtures shall not exceed 15A for
types A, G, J, B, F, K, or E.
• Maximum drive current through connected fixtures shall
not exceed 12A for types M, N, P, R.
IS series luminaires come in two versions: continuous units (ISC series) and independent units (IS1 series). A continuous electrical run
will consist of a number of continuous units up to a maximum current specified above. When installing luminaires use clean gloves
in order to avoid fouling the reflective surface. To insure a clean fixture, install the fixture with the plastic bag around the fixture, and
then remove plastic bag upon completion of any and all construction related activity.
Daintree Node Identification Label
2
1
Installation of an Independent Unit (IS1)
1
Carefully unpack unit and inspect for
defects before installing. Wear work
gloves to prevent dirt and oil from
being transferred to the luminaire.
NOTE: When installing luminaires use
clean gloves in order to avoid fouling
the reflective surface.
B,F or K
M,N,P or R
U,V,W or X
160'
80'
60'
320'
188'
132'
1
2
Choose suspension method
2
Attach mounting bracket to ceiling
support structure either directly or
using a GE suspension kit according
to the suspension kit instructions
(see page 2). Maximum distance
between suspension points shall not
exceed the length of the luminaire.
IS of Second Generation
[42] [84]
Voltage
120V
277V or 347V
• Maximum driver current through connected fixtures shall
not exceed 15A for lumen codes [42], [52], [84], or [A0].
• Maxiumum driver current through connected fixtures shall
not exceed 12A for lumen codes [65], [85], [A3], [A7], [A1],
[A2], [B1] or [B4].
Daintree Node identification label installed on luminaire back reflector.
Remove package with smaller label. This label is to be used for customer
floor plan or records.
3
Lumen Code
[65] [85]
[52] [A0]
[A3] [A7]
192'
160'
80'
400'
320'
188'
3
Prepare luminaire for installation
by loosening the PSU cover screws
and removing the cover.
[A1] [A2]
[B1] [B4]
60'
132'

Publicité

loading