Publicité
Notes:
1. If installing a single Sidekick, the
primary 448 will need to be moved
1-1/2" over from the center of
the cabinet.
2. The 448 Sidekick comes ready
for left-side installation. If right
side is preferred, remove the (2)
screws on the inside of the unit,
flip the slide assembly 180 degrees
and reinstall the screws.
Unit is not compatible with 448SW
Series pullouts.
STEP 1
Place the primary 448 on the floor.
Place the bottom product slide
assembly on the floor (or bottom
shelf) of the 448 with the slide
toward the back of the unit as
shown (See Figure 1).
Note: Make sure that the back
of the bent bracket is flush with
the side of the primary 448 and
install with (2) #8 x 1/2" deep
thread truss head screws.
#2
#2
#2
STEP 2
Lie the primary 448 on its side.
Using the measurements provided
and a 5/64" drill bit pre-drill (3)
screw holes. Remove the Sidekicks
TOP slide product member by
moving the black plastic lever to
the opposite side of the slide and
pulling the product member free,
and install it to the primary 448
with (3) #6 x 1/2" flat head screws
(See Figures 2A and 2B).
#2
#2
#2
5
64
2
FIG. 1
Bent bracket
(Flush)
FIG. 2A
13-5/32"
(334 mm)
Customer Service: 800-626-1126 | rev-a-shelf.com
FIG. 2B
3-1/4"
4-13/32"
(83 mm)
(112 mm)
1.00"
(25 mm)
Publicité
