Springlane BURNHARD Barney Guide De Montage Et D'utilisation page 43

The following parts are included in the delivery. They correspond to the applicab-
le standards for the country to which the gas barbecue is shipped:
• Gas hose (pre-installed): CE-appro-
ved hose of sufficient length (max. 1.5
m) that allows for buckle-free assem-
bly.
• Pressure regulator (pre-fitted to
gas hose): non-adjustable, CE-appro-
1. Unscrew the protective cover from
the screw connection on the gas bar-
becue. Attach the M6 nut on the end
of the hose to the screw connection
on the gas barbecue. Screw the M6 nut
tight using a spanner.
2. Place the gas cylinder into the
trolley.
3. Attach the M6 nut of the hose to
Leak test
Spray all sealing points with a standard, commercial leak detection spray or daub
them with soapy water (mix ratio: 1 part soap to 3 parts water). Open the valve
on the gas cylinder. Bubbles will form at leaking points. Close the valve of the gas
cylinder.
ved pressure regulator as per DIN EN
12864, max. 1.5 kg/h, operating pressu-
re: 50 mbar, corresponds to applicable
gas cylinder type.
the screw connection on the pressure
regulator and tighten the connection
using a spanner.
4. Attach the M6 nut on the pressure
regulator to the screw connection on
the gas cylinder. Tighten the M6 nut by
hand. Do not use any tools to do this,
as they could damage the seal.
43