Klarstein 10021357 Mode D'emploi page 7

A Lid Cover
B Filer
C Body
D Base
E Power Indicator Light
F On/Off Switch]
G Handle
H Thermometer
If you are using the kettle for the fi rst time, it is recommended that you clean your kettle before use by
boiling a full kettle of water twice and then discarding the water.
1. To fi ll water into the kettle, remove it from the power base and open the lid by pressing the lid
open button , fi ll with the desired amount of water to the kettle. Always fi ll the kettle between the
minimum (0.5L) and maximum (1.7L) marks. Too little water will result in the kettle switching off
before the water has boiled.
NOTE: Do not fi ll the water over the maximum level, as water may spill out of the spout
when boiling. Ensure that the lid is fi rmly in place before connecting the power cord to the
outlet.
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. Press the switch button below the handle. The indicating
lights inside the kettle will light up. Then start to boil the water. The kettle will switch off automatically
once the water has boiled and the light extinguishes. You can shut off the power by pressing the
switch button at any moment during boiling water.
NOTE: Ensure that switch is clear of obstructions and the lid is fi rmly closed. The kettle will
not turn off if the switch is constrained or if the lid is left open.
4. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may
result in scald, besides, don't open the lid while the water in the kettle is hot.
5. The kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20 seconds before
reopening to boil water. The kettle may be stored on the power base when not in use.
NOTE: Ensure power supply is turned off when kettle is not in use.
7
All manuals and user guides at all-guides.com
Kettle
Before initial use
Operation