Weidmüller PrintJet Mode D'emploi page 4

3. Safety precautions
3.1 Safety instructions
• Remove all shipping braces; open the PrintJet cover and remove the transport lock from the print head.
• Read the following instructions carefully before starting up the PrintJet. Observe the warnings and notices on the PrintJet at all times.
• Do not block or cover openings in the enclosure of the PrintJet
• Do not insert any objects into these openings.
• Do not spill any fluids onto the PrintJet.
• The mains voltage must correspond to the system voltage given on the PrintJet type plate.
• Connect the device to a properly earthed and fused socket outlet only. Do not use a socket outlet already being used by devices that are
turned on and off at regular intervals, such as photocopiers or ventilators.
• Do not connect the PrintJet to either a switched or a timer-controlled socket outlet.
• Do not use the computer system close to potential electromagnetic disturbance fields such as loudspeakers or base transceiver stations
for mobile telephones.
• Never use damaged or worn out power cables.
• If you connect the PrintJet to the power supply via an extension cable, ensure that the total nominal current of all of the devices connected
to the extension cable does not exceed the ampere rating for that extension cable. In addition, you should ensure that the total nominal
current of all the devices plugged into the wall-mounted socket outlet does not exceed the ampere rating for that socket outlet.
• Do not carry out repairs to the device yourself.
Unplug the PrintJet and contact a qualified service engineer if any of the following occurs:
• The power cord or plug become worn or damaged
• Fluid has penetrated into the PrintJet.
• The PrintJet is allowed to fall or the enclosure is damaged.
• The PrintJet does not operate normally or the standard of performance varies noticeably.
Caution:
Warning signs to BGV A 8 (VBG 125), German employers liability insurance regulations, & German stan-
dard DIN 4844.
Warning - Mind your hands
Do not reach inside
All manuals and user guides at all-guides.com
Warning – Hot surface
Do not touch
Caution:
Do not open the enclosure!
Do not open the enclosure of the printer!
Risk of injury!
There are no serviceable parts inside the printer.
You will forfeit all rights under the guarantee if you open
the enclosure!
Sealing label
3