Chauvet DJ EZgobo Manuel De Référence Rapide page 2

All manuals and user guides at all-guides.com
The EZgobo™ Quick Reference Guide (QRG) has basic product information. For
more information, download the User Manual from the CHAUVET® website:
http://www.chauvetlighting.com/product-manuals-literature/.
The information and specifications in this QRG are subject to change without
notice.
The following Safety Notes include important information about installation, use,
and maintenance.
•
Always connect the product to a grounded circuit.
•
Make sure the power cord is not crimped or damaged.
•
Always disconnect the product from the power source before cleaning it.
•
Never disconnect the product from the power source by pulling or tugging on
the cord.
•
If mounting the product overhead, make sure there is adequate support for the
product's weight and always secure the product using a safety cable.
•
Make sure there are no flammable materials close to the product when it is
operating.
•
Avoid direct eye exposure to the light source while the product is on.
•
Do not touch the product's housing when the product is operating because the
housing can be very hot.
•
The product is not intended for permanent installation.
•
The product is for indoor use only. It is rated at IP20.
•
Do not expose the product to rain or moisture.
•
Always connect the product to a power source that is within the voltage range
stated on the label or rear panel of the product.
•
Never connect the product to a dimmer or rheostat.
•
Always install the product in a location with adequate ventilation.
•
Always leave at least 20 in (50 cm) between the product and adjacent
surfaces.
•
Be sure that no ventilation slots on the product's housing are blocked.
•
Do not operate the product at an ambient temperature higher than
104 °F (40 °C).
•
Never carry the product by the power cord or any moving part.
•
Always use the mounting clamp or carry handle to lift the product.
•
If there is a serious operating problem, stop using the product immediately.
•
Never try to repair the product. Repairs carried out by untrained people can
lead to damage or malfunction.
•
From outside the U.S., UK, Ireland, or Mexico, contact the distributor of
record to request support or return a product.
•
From inside the U.S., UK, Ireland, or Mexico, use the information in
Contact Us at the end of this QRG.
2