Braun M-90 Mode D'emploi page 3

English
Batteries
This appliance operates on two 1.5 volt
batteries. For best performance, use
alkaline manganese batteries (type LR 6,
AM 3, MN 1500 or size AA alkaline, e. g.
®
Duracell ). These batteries provide a
shaving capacity of approx. 60 minutes.
To open the battery cover (6), turn it 90° as
shown in (c). Insert batteries with the poles
in the direction marked. Close the battery
cover.
Note: Never leave batteries in the shaver
for long periods of time when the shaver is
not in use (danger of leakage). Take empty
batteries out of the shaver immediately.
To protect the environment, dispose
of empty batteries at your retail store
or at appropriate collection sites
according to national or local regulations.
This appliance is suitable for use
in a bath or shower. When using it
in a shower, we recommend that
you apply shaving foam or gel.
Shaving
Turn the twisting protective cap (4) (a) until
it clicks in place as shown (b). To switch the
shaver on, push the on/off switch (3) up.
Long hair trimmer
(M-90 model only)
Use the extendable long hair trimmer (5)
for exact trimming of side burns and
moustaches. To operate, slide the long
hair trimmer to the right (e) and turn on
the appliance. After use, slide it back until
it engages.
Cleaning and maintenance
For optimum shaving performance, clean
the shaver after each use:
Cleaning under running water
Turn on the shaver and hold the shaver
head under warm running water (f).
You may also use liquid soap. Rinse off all
foam and let the shaver run for a few more
seconds. Then turn it off and remove the
shaver foil (1) as shown (g) and let it dry.
If you often clean your shaver under
running water, put a drop of light machine
oil onto the shaver foil.
Cleaning with the brush
Remove the shaver foil (1) and tap it gently
against a flat surface. Then thoroughly
clean the cutter block (2) with the brush (7)
as shown in (i). Do not clean the shaver foil
with the brush as this may damage it.
3
All manuals and user guides at all-guides.com