GE GFD49 Manuel Du Propriétaire Et Instructions D'installation page 7

Control settings.
Getting Started
1
Press the Power button.
If the screen is dark, a press
of the Power button will
"wake up" the display.
2
Select a dry cycle. (Defaults are set
for each cycle. These default
settings can be changed. See
Control settings for more
information.)
Power
1
Press to "wake up" the display. If the display is active, press to turn the dryer off.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
2
Dry Cycles
3
The dry cycle controls the length and tumble speed of the drying process. The chart below will help you match the dry
setting with the loads.
Normal/
Mixed Loads
Cottons
Bulky/ or
Bedding
Bulky Items
Active Wear
Delicates
Speed Dry or
Quick Dry
Towels/Sheets
Sanitize
Steam Dewrinkle
Full Loads
Warm Up
Air Fluff
Time Dry
All manuals and user guides at all-guides.com
Start/Pause
Press to start a dry cycle. If the dryer is running,
press it once and it will pause the dryer. Press it
again to resume the dry cycle.
For loads consisting of cottons and poly-blends.
For cottons and most linens. NOTE: Energy Star
For large coats, bed spreads, mattress covers, sleeping bags, blankets, comforters, jackets, small rugs,
and similar large and bulky items.
Clothing worn for active sports exercise and some casual wear. Fabrics include new technology
finishes and stretch fibers such as Spandex. Also for clothing labeled Easy Care or Perma Press: For
wrinkle-free and permanent press items.
For lingerie and special-care fabrics.
For small loads that are needed in a hurry, such as sports or school uniforms. Can also be used if the
previous cycle left some items damp, such as collars or waistbands.
Use for towels OR sheets. It is not recommended to mix towels and sheets in the same load.
Reduces certain types of bacteria by 99.8%, including: Staphylococcus aureus, Pseudomonas
aeruginosa, and Klebsiella pneumoniae. The antibacterial process occurs when high heat is used
during a portion of this drying cycle.
Provides 20 minutes of steam drying to assist with dewrinkling clothes.
for an extended time.
Provides 10 minutes of warming time to warm up clothes.
Provides 10 minutes of tumbling time without heat.
Use to set your own dry time. Time Dry is also recommended for small loads. To use:
1. Turn dry cycle dial to Time Dry.
2. Increase the drying time by pressing the Add Time button.
Note: This button only increases the time. When max time is reached, pressing the button again
will reset the counter to the lowest setting.
3. Select the Temp.
4. Close the door.
5. Press Start/Pause.
3
Press the Start/Pause button.
® models are tested on Cottons with default settings.
GEAppliances.com
Ideal for loads left in dryer
7