Team kalorik TKG SFC 1001 Mode D'emploi page 14

All manuals and user guides at all-guides.com
Fax +32 2 359 95 50
9. The small and large brushes, the scrubbing brush and the curved nozzle can be
assembled onto the straight nozzle.
10. Window wiper: Caution! Do not operate this appliance directly on cold glass. Otherwise
the glass may crack. Preheat the glass by spraying steam in a wider arc from a distance
of 20-25cm. Slowly reduce the distance to 10-15cm to preheat the glass further.
11. The window wiper must be attached to the scrubbing brush. First assemble the scrubbing
brush onto the straight nozzle. Take off the cloth from the scrubbing brush and connect
the window wiper to the brush by the two hinges. The window wiper can be dismantled
easily by unhooking the hinges again.
Window wiper
OPERATION:
1. Attach the appliance to the mains supply and press the on-off switch to switch the
appliance on. The green and red control lamps light up. As soon as the preheating (about
10 minutes) is terminated, the red heating control lamp goes out. The appliance is now
ready for use.
The appliance is equipped with a child safety device. To release
the locking device, push the triangular pin on the right-hand side o
the steam gun towards the left.
Press the steam button and move the appliance slowly over the s
cleaned. It is recommended that the distance between the nozzle and the surface
amounts to at least 2-3cm.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Scrubbing brush
Hooks
14
Assembly page 14/76
Hinges
f
urface which is to be
TKG SFC 1001 - 100525