Options And Accessories - Hatco Glo-Rite HL5-18 Manuel D'installation Et D'utilisation

English
Non-Adjustable Stands
Aluminum, non-adjustable stands are available as a factory-
installed option for the permanent mounting of Glo-Rite
Curved Display Lights to a countertop. They are available in
heights of 10" (254 mm), 12" (305 mm), 14" (356 mm), and
16" (406 mm).
1. Determine the exact mounting location on the countertop
for the unit.
2. Prepare the location of each stand mounting flange on the
countertop.
a. Cut out the mounting flange templates provided on this
page. Use the templates for accurate mounting hole and
conduit hole locations.
IMPORTANT NOTE
Make sure the page has not been scaled in size. Measure the
box on this page to check accuracy.
b. Refer to the "Stand Mounting Measurements" table
and the illustration later in this section for unit-specific
measurements.
c. Verify which stand will have the conduit passing through
it and the countertop.
d. Carefully measure, locate, and tape each template onto
the countertop at its appropriate position.
e. Drill holes through the approriate "Drill Here" locations on
each template.
Form No. HL5M-0417
Conduit
Drill Here
Hole Cutout Ø =
1-3/32"
(28 mm)
Stand Mounting Flange Templates
9

OPTIONS AND ACCESSORIES

3. Feed the conduit from the unit through the appropriate
holes, and position the unit on the countertop.
4. Fasten the stands to the countertop using appropriate
fasteners (not supplied by Hatco). Each mounting flange
has two mounting hole locations.
5. Have a qualified electrician perform the necessary electrical
connections to the on-site electrical system
NOTE: Mounting hole size will be determined by fastener size.
This box is
2" x 2" when
printed
correctly.
Check page scaling if box
is not 2" x 2" when printed.
Mounting
Hole
continued...