Replacing An Led Light Channel; Troubleshooting Guide; Corrective Action - Hatco Glo-Rite HL5-18 Manuel D'installation Et D'utilisation

MAINTENANCE

Replacing an LED Light Channel

Glo-Rite Curved Display Lights have two LED light channels
®
that illuminate the area below. These light channels have
special covers to guard against injury and food contamination
in the event of breakage.
To replace an LED light channel:
1. Turn off the unit, allow the unit to cool, and unplug the
power cord/disconnect the power supply at the circuit
breaker.
2. Release and remove the LED light channel from three
retaining clips—one on each end of the channel and one
in the middle.
• At each retaining clip location, grasp the inside edge of
the light channel, and carefully pull the channel down
and out of the clip.
3. Disconnect the LED wire lead connectors next to the LED
control box.
4. Connect the new LED light channel wire lead to the display
light wire lead.
5. Position the new LED light channel in the unit, and carefully
snap it into each retaining clip.
6. Tuck the LED wire leads neatly up into the space between
the light channel and the LED control box.

TROUBLESHOOTING GUIDE

WARNING
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
Symptom
Unit is turned "On" but there is
no light.
Light is inadequate.
Troubleshooting Questions?
If you continue to have problems resolving an issue, please contact the nearest Authorized Hatco Service Agency or Hatco
for assistance. To locate the nearest Service Agency, log onto the Hatco website at www.hatcocorp.com and click on
Find Service Agent, or contact the Hatco Parts and Service Team at:
Telephone: 800-558-0607 or 414-671-6350
e-mail: partsandservice@hatcocorp.com
Probable Cause
No power to unit.
LED light channels defective.
Switch is defective.
Wiring is open.
Unit mounted too high above target area.
LED light channel defective.
Incorrect power supply (low).
NOTE: Hatco LED light channels meet NSF standards for
food holding and display areas. For replacement
LED light channels part numbers, refer to the HL5
Series Replacement Parts List on the Hatco website
(www.hatcocorp.com).
LED Control Box
Replacing an LED Light Channel
ELECTRIC SHOCK HAZARD: Turn OFF power switch and
unplug power cord/turn off power at circuit breaker before
performing any cleaning, adjustments, or maintenance.

Corrective Action

Check circuit breaker/power cord and reset/plug in, if necessary.
Replace LED light channels. Refer to procedure in
MAINTENANCE section.
Contact Authorized Service Agent or Hatco for assistance.
Contact Authorized Service Agent or Hatco for assistance.
Lower unit, putting effective light closer to target.
Replace LED light channel. Refer to procedure in
MAINTENANCE section.
Check power supply to unit, making sure it matches rating on
the unit. If power supply is incorrect, change to match rating
on unit.
8
English
Retaining
Clip
LED Wire
Connector
LED Wire
Connector
LED Light Channel
WARNING
Form No. HL5M-0417