Publicité
Les langues disponibles
Les langues disponibles
2 | before first use
Before you use the appliance for the first time, please do
as follows: carefully unpack the appliance and remove
all the packaging material. keep the material (plastic
bags and cardboard) out of reach of children. check the
appliance after unpacking for any damage, possible from
transportation. before plugging into a socket, check
that the voltage in your home corresponds with the
voltage printed on the bottom of the appliance. put the
appliance on a flat, stable and heat resistant surface.
Before use you must fill the waterkettle to the maximum
level and boil this amount. do this twice. throw away
the boiled water and rinse the kettle with cold water.
the appliance is now ready to use. the kettle is only
suitable for boiling water. never fill the kettle with milk,
tea, coffee or other drinks. the minimum amount of
water must be 0,2 liters. the maximum amount of water
to be used is 1,0 liters.
All manuals and user guides at all-guides.com
3 | boiLing WAter
before plugging into a socket, check that the voltage in
your home corresponds with the voltage printed on the
bottom of the appliance. put the appliance on a cool,
flat and stable surface. Connect the appliance to an
earthed socket. you can adjust the length of the cord by
pulling it out from, or pushing it into, the interior of the
appliance.
1. Open the lid by pushing the button.
2. fill the kettle with an amount of water and close the
lid by pushing it down.
3. place the kettle on the base and make sure that the
plug is in the socket.
4. switch the kettle on by pressing the on/off switch
down to position 1.
The red pilot lamp will light up. The kettle will now
boil the
water.
5. the kettle will automatically switch off when the
water is boiled.
The pilot lamp will switch off.
if you want to boil the water again, you must wait
approx. 30 seconds before you switch it on again, so
that the switch can cool down. the kettle can also be
switched off at any time with the switch. When you take
the waterkettle off the base while boiling, it will switch
off. When you place the waterkettle back on the base
the water will continue boiling. if that is not necessary,
switch the kettle of by pushing the switch to position 0.
Attention! never switch the kettle on without water.
if, for whatever reason, the kettle is switched on without
water, the dry-boilprotection will automatically switch
the kettle off. put the switch back to "0". in this case
take the kettle off the base and let it cool down for
several minutes. After that, refill the kettle and switch it
on again. make sure that the lid is closed properly, if not
the kettle will go on boiling and will not automatically
switch off.
Attention! it may occur that you see condensation on the
base. this is completely normal and has no consequences
for the use of the waterkettle.
14
Publicité
