Yakima HookUp Instructions De Montage page 3

FLIP TIRE WIRE.
Flip the tire wire
toward the center of
the carrier.
SWING PIVOT ARM INTO PLACE.
Rotate the pivot arm up until
the hook rests on the bike
tire 1" from the brakes.
SECURE REAR
WHEEL STRAPS.
Feed the strap through
the spokes of wheel.
Rotate the wheel
slightly, if necessary.
READ ALL WARNINGS ON NEXT PAGE
BEFORE DRIVING AWAY.
1033335B-3/12
All manuals and user guides at all-guides.com
RELEASE REAR
WHEEL STRAP.
Push the tab and
lift the strap out.
CAUTION:
If any part of your bike
comes in contact with
the red trigger, do not
use this carrier with
that bike.
TIGHTEN REAR
WHEEL STRAPS.
• Insert the strap end through the
top of the ratchet buckle.
• Be sure the pad rests on the rim.
PAD
Move the ratchet tab up and down
to tighten the strap.
LOAD HEAVIEST BIKE FIRST.
Make sure your tires are
filled to recommended
pressure found on the tire.
SECURE THE HOOK.
Compress the hook against
the wheel by applying firm
pressure.
PUSH HARD!
CHECK THE
INSTALLATION BEFORE
DRIVING AWAY.
• PUSH HOOKS AGAINST TIRES.
• REAR WHEELS SECURED BY
RATCHET STRAPS.
• BE SURE ALL HARDWARE IS
SECURED ACCORDING TO
INSTRUCTIONS.
• ALWAYS SECURE PIVOT ARM
WHEN TRAY IS EMPTY
(NEXT PAGE).