Paradigm Reference OM-605 Mode D'emploi page 10

INSTALLATION INTO A PARADIGM
Connect subwoofer as outlined in the Owners Manual included with your Paradigm
and Paradigm ® Backbox installation instructions.
INSTALLING INTO
5/8˝ DRYWALL
All other installations go
directly to Fig. 7.
Fig. 6
Installation into 5/8˝ drywall requires additional sealing around ports. Peel backing and carefully align
port gaskets with rim of ports (as shown) . Press to adhere.
Fig. 7
To prevent air leaks, before installing subwoofer, apply gasket tape (included with subwoofer) along all
four outer edges of box, overlapping tape at corners (as shown in Fig. 7). Remove port covers by pressing
them out (as shown) .
Holding subwoofer firmly, push it into backbox being careful to align top holes in subwoofer frame with
top holes in backbox. Screw in until firm but not fully tightened. Continue holding subwoofer while lining
up all bottom holes. Again, screw in until firm but not fully tightened. Insert remaining screws. Tighten
all screws.
INSTALLING GRILLE
Fig. 8
10
® BACKBOX
® subwoofer amplifier
For subwoofer to
function correctly
and avoid damage
to amplifier or subwoofer, the
Impedance Matching Switch
must be correctly positioned.
Move the switch position to
reflect designated amplifier.
(Fig. 1) Refer to the Owners
Manual included with the
amplifier for more info.