Publicité
WATER FILTER SYSTEM WITH REMOVABLE FILTER
Your Kettle is equipped with a unique Water Filter System which
prevents scale particles from getting through the Kettle spout. This
Water Filter is removable for cleaning.
You must clean the Water Filter whenever there are any
noticeable deposits left on the Water Filter or if the rate of pouring
begins to reduce.
1. Before fitting or removing the Water Filter, empty the Kettle,
turn the Kettle OFF (0), and allow it to cool down completely.
2. Remove the Kettle from its Power Base.
3. Remove the Lid from the Kettle.
4. Press gently down on the tab at
the top of the Water Filter to
release it from the Kettle rim then
pull gently away from the spout.
WARNING: Do not use excessive
force, as this might
damage the Water Filter.
5. Grasp the Water Filter gently by
the edges, keeping your fingers
clear of the mesh, and pull it out
through the top of the Kettle.
6. To clean the Water Filter, rinse it under a tap while brushing it
with a soft brush.
7. Replace the Water Filter. Make sure that your hands are clean
and free from soap, cream or anything which might taint
the water.
8. Tilt the bottom of the Water Filter forward slightly and ease it
forward, toward the spout, until the bottom of the Water Filter
engages in the groove between the Kettle wall and the
bottom of the Kettle.
9. Push gently down on the tab at the top of the Water Filter, to
ease the Water Filter under the rim, then push forward, toward
the spout. The two guides on the front of the Water Filter
should fit into holes in the metal plate covering the spout.
NOTE: To work properly, the Water Filter must be located centrally
behind the spout.
10. Rinse the Kettle with fresh water and it's ready for use.
7
Publicité
