Publicité
Les langues disponibles
Les langues disponibles
Aligning the source levels
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode's
volume to almost the same level.
1
Press SRC (SOURCE) repeatedly to select the
desired mode.
2
Press D (DSPL) while pressing S (SEL).
"LEVEL 0" appears on the display.
3
Press + or - to adjust the level.
Note
Adjust the level within 5 seconds, or this function will be
canceled.
Restoring the factory settings
1
Turn off the unit.
2
Press and hold D (DSPL) until "LEVEL --" appears
on the display.
Note
You can restore the factory settings only for VOL, BASS,
TRE, BAL, FAD, H-BASS, DSSA and BBE as well as
aligned source volume levels.
Setting the beep tone
1
Turn off the unit.
2
Press and hold S (SEL) until "BEEP" appears on the
display.
3
Press + or - to select "ON" or "OFF".
4
Press S (SEL).
The unit turns off.
Setting the clock
1
Press and hold D (DSPL) until the clock indicator
flashes on the display.
2
Press r (to set hour) or t (to set minute)
and press + or -.
3
Press D (DSPL).
Displaying the clock
1
Press D (DSPL).
To return to the former display, press D (DSPL)
again.
RADIO OPERATION
Tuning in to a station
(Seek/Manual Tuning)
r/t
TU(TUNER)
Band indication
Frequency indication
1
Press TU (TUNER) repeatedly to select the desired
band (
,
,
2
Press t (to move to higher frequencies) or r
(to move to lower frequencies) to tune in to a station.
"ST" appears on the display when an FM station is
broadcasting in stereo, and receiving conditions are
good.
Seek Tuning and Manual Tuning
• Press and hold t or r until Seek Tuning
starts.
The unit locates a station automatically (Seek
Tuning).
To stop Seek Tuning, press t or r again.
• Press t or r repeatedly to search for a
desired station while increasing or decreasing the
frequency step by step (Manual Tuning).
Monaural mode
When FM signals become weak, or FM reception
becomes poor, the unit automatically switches to
Monaural mode to reduce noise.
Note
When stereo sound is received, you can also press ST
and select "MONO" to listen in monaural mode.
To resume stereo sound receiving, press ST to "AUTO
ST".
Local mode
Local mode allows you to tune in only to strong stations
during Seek Tuning.
1
Press LO before you start seek tuning.
"LO" appears on the display.
To return to Distant mode, press LO again.
"LO" disappears and the unit tunes in to all receivable
stations.
ST
LO
Stereo indicator
Local indicator
Tuner indicator
,
or
).
ENGLISH
ENGLISH
4
4
Publicité
