13.2 Security instructions
Missing or non-readable security stickers have to be replaced immediately!
The locally applicable laws and regulations may specify the minimum age of the
operator and limit the use of this machine!
To avoid malfunction, machine defects and injuries, read the following security instructions!
Keep your work area dry and tidy! An untidy work area may cause accidents. Avoid
slippery floor.
Make sure the work area is lighted sufficiently
Do not overload the machine
Always stay focused when working. Reduce distortion sources in your working
environment. The operation of the machine when being tired, as well as under the
influence of alcohol, drugs or concentration influencing medicaments is forbidden.
Work in a well ventilated area!
Respectively trained people only and only one person shall operate the machine.
Do not allow other people, particularly children, to touch the machine or the cable.
Keep them away from your work area.
Make your workshop childproof.
Make sure there is nobody present in the dangerous area. The minimum safety
distance is 2m
Use personal safety equipment: dust mask when working with the machine.
Never leave the machine running unattended! Before leaving the working area
switch the machine off and wait until the machine stops.
Always disconnect the machine prior to any actions performed at the machine.
Avoid unintentional starting
Do not use the machine with damaged switch
The plug of an electrical tool must strictly correspond to the socket. Do not use any
adapters together with earthed electric tools
Each time you work with an electrically operated machine, caution is advised! There
is a risk of electric shock, fire, cutting injury;
Protect the machine from dampness (causing a short circuit)
Use power tools and machines never in the vicinity of flammable liquids and gases
(danger of explosion)
Check the cable regularly for damage
When working with the machine outdoors, use extension cables suitable for outdoor
use
Do not use the cable to carry the machine
Protect the cable from heat, oil and sharp edges
Avoid body contact with earthed
FIRE HAZARD:
Especially the aspiration of lightly flammable materials like gases, liquids, metal dust
or chippings, solvents, hot ashes, cigarette waste ... is strictly forbidden!
Do not insert any objections into the dust collector hood and keep hand away from
the dust collector hood when machine is connected to power supply.
Regularly check the dust collector hood for debris and clean it if necessary.
Do not dismount the protective fence in the dust collector hood. It is a security
component and must be left in place.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
SAFETY
23
ABS 850