Krups XP2280 Mode D'emploi page 96

English
n Hold down the
n When the desired amount of espresso is obtained, press the
saved automatically.
n The next time you press the
n You can programme for 2 cups in the same manner, by pressing the
3 . STEAM FUNCTION
n Steam is used to foam up the milk (for example, to make a cappuccino or a cafe latte).
n To produce steam, the pump works by emitting an intermittent noise.
n After using the steam function, the appliance cools automatically by pumping cold water
through the heating system. During the pumping cycles, the excess steam in the heating system is
released with the hot water into the drip tray.
n The release of steam and the accompanying noise are required for the appliance to cool
down.
WARNING:
During and after using the appliance, the metal parts of the steam nozzle can
become very hot.
USING THE STEAM NOZZLE TO FROTH MILK
n Fill the water tank and turn on the appliance (fig.1, 2, 3 et 4).
n After a few moments, the
n Press the
button (fig. 12). During the pre-heating, the
n Move the steam nozzle towards the outside of the appliance.
n Pour 60 to 100 ml of very fresh, very cold milk in a narrow container of about 1/2 litre and which can
pass under the steam nozzle. The milk (UHT or pasteurised) and its container should be quite cold.
n As soon as the appliance reaches the right temperature, the
steadily.
n Immerse the steam nozzle into the milk and turn the knob to
Espresso
n The
LED and the pictogram
flash after a few moments.
n For best results, hold the nozzle towards the bottom of the container for about 25 seconds while the
milk heats up (without however touching the bottom of the container). Then, bring the container down
gradually so that the nozzle moves up towards the surface (without the nozzle coming out of the milk)
(Fig. 14).
n Once the froth has been formed, turn the knob to "0" position (Fig. 15). The appliance will now
automatically cool down by launching intermittent pumping cycles. Once this automatic operation is
complete, you can make a coffee.
IMPORTANT : To prevent the steam nozzle from being clogged, the milk foam must
never reach the black plastic upper part.
It is important to clean the steam nozzle after each use to prevent the milk from drying on the inside of the
nozzle. To do this:
n Place the steam nozzle in a container with water and repeat the milk frothing operation for 30 seconds.
WARNING!
The steam nozzle will be hot!
92
All manuals and user guides at all-guides.com
button ( > 3 sec) until the pictogram
, button, you will obtain the most recently recorded amount.
Espresso
button glows steadily
remain steady when the steam begins to be produced and can
flashes quickly. The coffee flows out.
. button. This amount will then be
button ( > 3 sec).
Espresso
LED and the pictogram
Espresso
LED and the
position (fig.13).
flash.
pictogram glow