Winix HR1000 Manuel D'utilisation page 17

All manuals and user guides at all-guides.com
FILTER CARE
3. Filter Assembly and Replacement
Filters should be re-installed in the reverse order of their removal.
Insert the replacement
3 Anti-microbial True HEPA filter
2 CD Carbon filter
x Remove the protective plastic wrap from
new ilters. Operating the unit without
removing the protective plastic wrap may
cause abnormal noise, deformation, or ire as
a result of overheating.
Insert the 1 Pre-filter (front).
x To install the pre-ilter, insert bottom tabs
into the slots on either side of the lower part
of the unit, then rotate upward to insert the
upper tabs into the slots at the top part of
the unit until both sides audibly click into
place.
Replace the front panel by first inserting
the latch at the bottom edge into the
base of the unit, then rotate the panel
upward toward the top of the unit until
it magnetically snaps closed.
English
(rear)
(middle)
Care and Maintenance
3 Anti-microbial
True HEPA filter
2 CD Carbon
filter
17
HR 1000