Télécharger Imprimer la page

AL-KO BLOWER VAC 2400 E SPEED CONTROL Mode D'emploi page 20

Masquer les pouces Voir aussi pour BLOWER VAC 2400 E SPEED CONTROL:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
GB
Trouble-shooting
Trouble
Machine does not work
Machine cuts out intermit-
tently
Reduced sucking / blow-
ing power
Sucking / blowing power
too feeble
For faults not listed in this table, or which you cannot resolve by yourself, please contact our customer service.
Warranty
If any material or manufacturing defects are found during the statutory customer protection period, we will either
repair or replace the equipment, whichever we consider the more appropriate.
This statutory period may vary according to the legislation in force in the country where the equipment was
purchased.
Our warranty is valid only if:
„ The equipment has been used properly
„ The operating instructions have been followed
„ Genuine replacement parts have been used
The following are not covered by warranty:
„ Paint damage due to normal wear
„ Wear parts identified by a border XXX XXX (X) on the spare parts list
„ Combustion motors – these are covered by a separate warranty from the manufacturer concerned
To make a claim under warranty, please take this statement of warranty and proof of purchase to the nearest autho-
rized customer service centre.
This warranty does not affect the usual statutory rights of the customer relative to the seller.
20
All manuals and user guides at all-guides.com
Possible cause
No power supply
Power cable defective
Extension lead damaged
ON / OFF switch defective
Pre-separator full
Collection sack full
Extension lead too long
Extension lead conductor cross-
section too small
┌──────┐
└──────┘
Solution
Check fuse / extension lead
Contact AL-KO Service Centre
Exchange extension lead
Contact AL-KO Service Centre
Empty the pre-separator
Empty the collection sack
Limit the extension lead length to a maximum
of 50 m
Use an extension lead with a conductor cross-
section of at least 3 x 1.5 mm²
The warranty is no longer valid if:
„ The equipment has been tampered with
„ Technical modifications have been made
„ The equipment was not used for its intended pur-
pose (for example, used for commercial or communal
applications)
Translation of original user instructions
Blower vac

Publicité

loading

Ce manuel est également adapté pour:

Blower vac 2200 e