AL-KO BLOWER VAC 2400 E SPEED CONTROL Mode D'emploi page 18

GB
Operation
Use for the first time
Warning!
Do not use the machine until it has been fully
assembled.
„ The plug and socket on extension leads must be
made of rubber, plasticized PVC or other thermo-
plastic material with the same mechanical strength,
or be clad in this material
„ The extension lead must not be to a lower specifi-
cation than:
light-duty rubber sheathed cable H05 RN-F
„
to VDE 0282 part 8
sheathed cable with polyurethane cladding
„
to VDE 0282 part 10
„ Keep children away from the machine whilst it is
plugged into the mains
„ Plug the machine only into mains sockets that are
protected with a residual-current device (RCD) with
a triggering current of max. 30 mA
„ The plug connectors of extension leads must be
splash-proof
„ Do not remove any protection devices
Transport
Warning – risk of damage!
Do not unplug the machine by pulling on the
power cable.
Unplug it by grasping the plug to withdraw it!
„ When carrying the machine always hold it by the
handle or carrying strap
„ Do not use the rollers for transporting the machine
18
All manuals and user guides at all-guides.com
Operation
„ Regularly check the power cable and extension
„ If a cable is damaged in use, immediately discon-
1. Plug the mains plug into the extension lead socket.
2. Secure extension lead by inserting it into the strain
3. Plug the extension lead plug into the mains socket.
Switching on
„ Press the ON / OFF switch in and keep it pressed.
Switching off
„ Release the ON / OFF switch
Selecting the operating mode
The operating mode is selected using the changeover
lever:
(
„ Move the changeover lever to position
„ Move the changeover lever to position
The operating mode can be selected when the motor is
running or when it its stopped.
Setting the sucking / blowing power
(only for Blower Vac 2400 E speed control)
„ Turn the speed controller clockwise:
„ Turn the speed controller anti-clockwise:
Warning – risk of injury!
Do not operate the machine without a collection
sack.
Close the zip on the collection sack..
The blower-vac will not work unless the sack
frame is attached to the housing
(safety switch).
leads for signs of damage; use them only if they are
in faultless condition!
nect it from the mains!
12, 13).
relief (
15, 16)
- Sucking mode is selected
- Blowing mode is selected
- sucking / blowing power is increased
- sucking / blowing power is decreased
Translation of original user instructions
Blower vac
:
:
17)
(