AL-KO BLOWER VAC 2400 E SPEED CONTROL Mode D'emploi page 17

2200 E / 2400 E
„ Wear appropriate working clothes:
Safety glasses
„
Protective gloves
„
Ear defenders
„
Face mask for dust protection
„
Sturdy footwear
„
Long trousers
„
„ Keep the following items away from the suction
intake:
Loose hanging clothing
„
Jewellery
„
Long hair
„
„ Keep all cooling air inlets clear of rubbish.
„ Never blow rubbish towards people.
Assembly
Warning!
Do not use the machine until it has been fully
assembled.
Fitting the carrying handle
1. Insert the square nut into the carrying handle
( 2).
2. Push the carrying handle on to the housing (
3. Set the carrying handle to the desired position.
4. Insert the bolt (M6×100) into the carrying handle
( 4).
5. Tighten the carrying handle bolt.
Fitting the changeover lever
1. Place the grip piece in position (
2. Insert the bolt (Ø 3.5 × 16) into the grip piece.
3. Tighten the grip piece bolt.
Fitting the collection sack
1. Place the collection sack belt over the support pin
on the sack frame and place it around the sack
frame collar.
2. Ensure the locking bracket engages in the eye of
the collection sack belt (
3. Carefully tighten the collection sack belt using the
nut and bolt (M4×30) (
470 602_b
All manuals and user guides at all-guides.com
3).
5).
( 6)
7).
7).
Fitting the pre-separator
1. Slide the lower edge of the pre-separator into the
sack frame ( 8).
2. Click the upper edge of the pre-separator home in
the sack frame ( 8).
Fitting the sack frame
1. Hook the sack frame on to the suction duct stub
( 9/1).
2. Pull the sack frame upwards slightly (
3. Allow the carrying handle to click home into the
housing ( 10).
Fitting the carrying strap
1. Insert the carrying strap carabiner hook into the belt
retainer on the machine (
2. Adjust the belt length so that the machine can be
guided just clear of the ground.
3. Only for Blower Vac 2400 E speed control:
Place the belt padding around the shoulder area of
the carrying belt, and close the Velcro fastening.
Fitting the rollers
1. Push the left and right rollers on to the roller carrier
until they click home (
2. Insert the roller carrier into the slot on the underside
of the sucking / blowing duct until it clicks home
21, 22).
(
GB
9/2).
11).
19, 20).
17