Publicité
Les langues disponibles
Les langues disponibles
E
E
FLG5 – Pressure-Feed Spray Gun
Read and follow all instructions and Safety warnings before using this
The FLG5 pressure feed Spraygun is fitted with a 1.4mm Nozzle for use with common
coating materials. A 1.1mm Nozzle and Needle is available as an alternative. The
FLG5 Spraygun is approved to ATEX regulations 94/9/EC, protection level;
II 2 G X. Suitable for use in Zones 1 and 2
Important: These spray guns are suitable for use with both water-based and solvent-
based coating materials. The design uses EPA compliant atomising (Devilbiss Trans-
Tech®) technology to reduce overspray and improve coating efficiency. Nozzles and
needles are manufactured in stainless steel. These guns are not designed for use with
highly corrosive and/or abrasive materials and if used with such materials it must be
expected that the need for cleaning and/or replacement of parts will be increased. If
there is any doubt regarding the suitability of a specific material contact your local
Distributor or ITW Finishing direct.
Air supply connection –
Maximum static air inlet pressure –
Nominal gun inlet pressure with gun triggered – 2.4 bar (35 psi)
Maximum Service temperature –
Gun Weight –
Airflow –
Gun body
–
Nozzle
–
Needle
–
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
© 2005 ITW Finishing Systems and Products
All manuals and user guides at all-guides.com
Operation Manual
Important
equipment
Description
SPECIFICATION
Universal
P
40°C
930g
277 l/min (9.8 cfm)
Materials of Construction
Aluminium. Stainless steel fluid passages
Stainless steel
Stainless Steel
2
1
/
BSP and NPS
4
= 12 bar (175 psi)
1
Publicité
