GE GXSS20B Manuel Du Propriétaire Et Directives D'installation page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
Water hard sometimes
Water feels slippery
after installation of
water softening system
Water softening system
not using any salt
Water is blue color
after water softening
system was installed
Water softening system
not regenerating
Cloudiness on glassware
(automatic dishwashers)
Salty tasting water
after installation
Possible Causes
Using hot water while the water
softening system is regenerating
Too few regenerations or more
water being used
Grains of hardness in your water
supply have increased
Absence of hardness minerals
Possible salt bridge
Possible plugged nozzle and venturi
Acidic water in copper plumbing
No power to unit
Mechanical defect
Combination of soft water and
too much detergent
Insufficient backwash and
rinse time
Low water pressure
Restricted drain hose
What To Do
• Avoid using hot water during water softening system
regenerations because the water heater will refill with
hard water. See Automatic Hard Water Bypass During
Regeneration section.
• See Regeneration Chart for correct setting.
• Water hardness can change over time, especially in well water.
To check, have the water tested by a water analysis laboratory
or call your local water department. Adjust the timer
settings as needed. See Regeneration Chart.
• This is normal.
•See the Operating Instructions, Tips section.
•See the Operating Instructions, Tips section.
•Have the water tested at once.
WARNING: Do not drink the water until problem has
been corrected.
•Check the circuit breaker or fuses.
•Call for service.
•This is called etching and is permanent. To prevent this
from happening, use less detergent if you have soft water.
Wash glassware in the shortest cycle that will get them clean.
•Press and hold TOUCH or HOLD button until RECHARGE
starts to flash to start a regeneration.
•At completion of regeneration cycle (approx. 2 hrs), run
water from faucets to purge the salty water.
•Check pressure; should be minimum 20 psi.
•Clean and reconnect hose.
www.GEAppliances.com
19

Publicité

Table des Matières
loading

Table des Matières