probst BSZ-KH-6.0 Instructions D'emploi page 43

Adjustments
Fig. 4
5.1.1 Adjusting of the dead Point
If the gripping range is adjusted correct according to
chapter "Adjusting of the gripping range", the stop
nut must be adjusted to the measure of 60±2 mm
(see figure 5).
To ensure symmetrical adjustment of the gripper
arms of the BSZ-KH unit, check whether the
crossbar runs parallel (//) to the upper part of the
unit (Fig. 6).
53100411
Lower
measuring
point on
spindle
Detail
2
Detail 1
Upper measuring
point on spindle
Fig. 6
14 / 20
Stop nut
60 ± 2 mm
Stop
Detail 1
Detail 2
Fig. 5
Crossbar
GB