Publicité
Les langues disponibles
Les langues disponibles
Always confirm that the burner control knob is in the off position before
connecting the gas sup.
Do not obstruct the flow of combustion air and ventilation air to the
appliance.
To Connect:
1. Ensure that there is no debris caught in the head of the gas cylinder, head
of there regulator valve.
2. Insert the nipple of the valve coupling into the cylinder valve and tighten
the black coupling nut by turning it clockwise with one hand while holding
the regulator with the other hand. (See diagram.) Hand tightens only.
To Disconnect:
1. Always confirm that the cylinder valve is in the OFF position before
disconnecting the gas supply.
2. Hold the regulator with the one hand and loosen the black coupling nut by
turning it counter-clockwise with the other hand.(See diagram.)
IMPORTANT
Disconnect the propane cylinder from the regulator valve when the
appliance is not in use.
SELECTING A LOCATION
Always place this outdoor appliance on a hard, level non-combustible
surface such as concrete, rock, or stone.
Minimum Clearance from Unit to Combustible Materials 48"(121.9cm) from
the top; 72" (182.9cm) from all sides and back. Do not locate this appliance
under any overhead enclosure.
Position the appliance so that you have easy access to the control knob.
20
MIN.CLEARANCE
72in (182.9cm)
MIN.CLEARANCE
72in (182.9cm)
VISUAL CHECK
Dumer
tube
Metal flex
tube
Peguletor
hase
Qnincgi
Prior to each use, check the hose and valve for excessive wear or
abrasions.
LEAK TEST
1. Perform a leak test in well-ventilated area outside
2. Make sure any open flames or cigarettes are extinguished.
3. Remove the battery.
4. Ensure the burner control knob is in the"OFF" position
5. Ina bowl, create a soapsolutionusing1 part water and1part liquid
detergent
6. Apply the soapy water solution to all connections.
7. Open the LP tank valve.
8. A gas leak will be detected by expanding bubbles originating from the
point of the leak.
9. If a leak is found at any connection point or if you smell gas, close the
tank valve, disconnect the tank, and do not use the appliance until repairs
can be made.
TO LIGHT
TIPS: Before Beginning Read and understand the instructions thoroughly.
Check and make sure that all parts are present.
For future reference, save this instruction sheet.
1.Locate the burner control knob and make sure it is in the "OFF" position.
2.Connect propane (LP)cylinder. (See above pages).
3.Open LP tank valve slowly.
4.Push in igniter button to create sparks at the electrode and hold.
5.Push and turn burner control knob to the"LOW" position.Continue to push
the control knob for 5 seconds after ignition.
21
Publicité
