Publicité
Les langues disponibles
Les langues disponibles
3
Install Wall Strip Extensions
Slide one end of Wall strip connector into
top two notches of short Wall strip.
Slide other end of the Wall strip connector
into the bottom two notches of the long
Wall strip. Use a spirit level to position the
short Wall strip and mark the position of
the top and bottom screw holes.
Drill a pilot hole and fasten both screws (Use wall anchors if
there is no stud). To position the second Wall strip Extension,
use Track Cover to ensure proper spacing from the first Wall
strip Extension.
14
4
Install Brackets & Adjustable Shelves
'B' SHELF ON TOP
'A' SHELF BELOW
through the front edge of the shelf.
NOTE: For maximum weight capacity, do not insert Bracket into
bottom slots of Upright.
IMPORTANT: Regardless of overall shelf length, when
overlapping sections of shelving, shelves labelled A must be
placed onto Brackets before shelves labelled B.
Insert Brackets into
Uprights at desired
locations. NOTE: Install
Brackets and shelving at
the top first and work
down.
Brackets will not fit into
upper slot of each Upright.
Shelves are fully
adjustable and require
no cutting. To adjust
width, overlap the
shelves making sure
the shelf labelled A is
placed first on the
Brackets and the shelf
labelled B is placed ON
TOP of A.
Make sure the
Bracket locks are
unlocked (the plastic
locking clip should
be in a vertical
position - upright)
and install shelving
making sure that the
'nose' of the Bracket
is projecting out
15
Publicité
