Remington smooth & silky WDF4815C Mode D'emploi page 6

ENGLISH
CARE FOR YOUR SHAVER
To ensure long lasting performance of your shaver, clean the head assembly regularly. The easiest and
the most hygienic way to clean the shaver is by rinsing the shaving head after use with warm water.
Always keep the protective cap on the shaving head when the shaver is not in use.
AFTER EACH USE
Ensure the shaver is turned off.
Press the side release button to slip open the head assembly.
Blow any loose debris from the foil.
Brush or rinse the accumulated hair from the main body of the shaver, head assembly and cutter
assembly.
Leave the head assembly open to let the shaver dry completely.
NOTE:
The lady shaver is suitable for use in the bath or shower.
Do not rinse with water hotter than 70ºC.
Do not completely submerge the lady shaver in water.
Ensure that the lady shaver is turned off and when cleaning.
Do not clean the shaving foils with the brush.
At regular intervals, put a drop of sewing machine oil onto the foils and cutter heads.
REPLACING YOUR FOILS AND CUTTERS
To ensure the continued highest quality performance from your shaver, we recommend that the foil and
cutter are replaced every 6 months. These can be obtained from our nearest Remington
Signs that your foils and cutters need replacing:
Irritation: As foils get worn, you may experience skin irritation.
Pulling: As the cutters wear, your shaver may not feel as close and you may feel the cutter pulling your
hair.
Wear through: You may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL
Ensure the lady shaver is switched off.
Gently push the small plastic area at either end of the foil. The foil should then easily detach from the
head assembly.
To reassemble, slide the foils into foil brackets and click into position.
Close the head assembly.
CAUTION
Only hold the plastic to prevent damage to the foil.
Do not press on the foil when replacing.
TO REPLACE THE CUTTERS
Ensure the shaver is switched off and open the head assembly (as above).
To remove cutter, grasp cutter between thumb and forefi nger and pull upward.
To reassemble cutter, place cutter onto oscillator tip. Gently push down clicking into position.
100650_REM_IFU_WDF4815_21L.indd GB3 100650_REM_IFU_WDF4815_21L.indd GB3
All manuals and user guides at all-guides.com
®
Service Centre.
3
31.08.10 23:17 31.08.10 23:17