König Electronic SEC-ALARM200 Manuel page 19

All manuals and user guides at all-guides.com
ADVANCED PROGRAMMING
Alert Zone (Bypass Zone)
As explained earlier, the control panel can operate in 2 different modes, 1) Alert Mode, 2) Alarm Mode. In
alarm mode, when a sensor is triggered, the control panel will either give a 30 seconds entry delay, or siren
will sound immediately (with instant alarm). However, there are sensors that you do not want to trigger the
alarm when the system is armed. Such as an outdoor sensor, or any other sensors that you only want to give
you alert notification. Under such circumstances, zone(s) can be programed to react only when the control
panel is in alert mode, these zones will be automatically bypassed when the control panel is in alarm mode.
These zones can also be considered as "Bypass zones".
It is recommend to enable alert zone if:
- You do not consider the sensors in that zone an emergency
- Sensors in that zone are located outdoors
- When nobody is home, you do not want to know the status of the sensor(s) in that zone
Factory Default: This feature was disabled for all zones at the factory.
To enable alert zone feature, follow the instructions below.
Step Keys

1 [PROG]
[MPIN]

2 [8]

3 Disable
Alert Zone:
[1] to [5]

Enable Alert
Zone: [6] to
[0].

4 [PROG]
[MPIN]
DISABLE
ALERT ZONE
Zone 1 Button [1]
Zone 2 Button [2]
Zone 3 Button [3]
Zone 4 Button [4]
Zone 5 Button [5]
Function Description
Enter Programming Enter master
password to
mode
programming mode
Select Alert Zone.
Select which zone Refer to the diagram
you would like to below to select the
select as Alert Zone. appropriate setting.
Enter Programming
mode
ENABLE
ALERT ZONE
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
19
Note
3 beeps for valid password. 1
long beep for invalid
password.
After [8] is entered some
zone LEDs will flash or stay
on. This indicates whether
alert zone is selected.
If alert zone is selected, that
zone LED will be on. If it is
not selected, the LED will
flash. You are allow to make
multiple changes before
terminating programming
mode.
PROG LED will be off.
This row:
Buttons to Disable Alert Zone
Zone LED: Flash
This row:
Buttons to Enable Alert Zone
Zone LED: ON