Publicité
Regulating power
Users should have some experience in use in order to regulate the power of the stove since there are
various factors which can affect its operation, such as chimney under-pressure and fuel characteristics.
Follow our guidelines and make your use easier.
The power is regulated by the regulator placed on the door.
The stove power depends on the chimney under-pressure (draw force). In cases of high level chimney
under-pressure it is recommended to lower it by operating the flue pipe flap.
- Nominal power
- Minimal power – set the regulator to 1/3
- In order to keep the fire burning overnight – set the regulator in
such a way to secure enough glow in the morning to keep the fire
burning normally during the day, and it is also about 1/3
Firing in the transition period
When firing the stove during the transition period (when the outside temperature is higher than 15° C),
there could be a lack of chimney under-pressure. In such cases try to achieve the necessary under-
pressure by firing up the chimney. If you should fail in this, we suggest you do not try to fire the stove. It is
advisable to open the doors and windows in the room while firing the stove in order to secure the pressure
balance in the closed space with the outside one.
Care and cleaning
After each heating season it would be advisable to clean the residual soot on the stove, flue pipes and
chimney. If regular care and cleaning are neglected, this could increase the possibility of fire breakout in
the chimney. If fire should appear in the chimney, follow these steps:
1. Do not use water to extinguish the fire
2. Close all the sources of air flow into the stove and chimney
3. After the fire is put out, call the chimney sweeper to examine the state of the chimney
4. Call the maintenance and assistance service, that is the manufacturer, to examine the
stove.
The stove is coated in high temperature resistant paint. After the paint layer hardens (following the
second or the third firing) all the stove surfaces can be evenly swept by a damp soft cleaning cloth.
After an extensive use the paint above the furnace can start to fade. These places can be re-painted by a
high temperature resistant paint. You can purchase suitable paint in specialized hardware stores.
Should you encounter any difficulties in daily operation of the stove (the appearance and spread of
smoke), please contact your licensed chimney sweeper or the closest service and maintenance. Only
licensed maintenance personnel can perform any work on the stove, and only original spare parts can be
used.
It's used for cleaning enamel and painted parts using soap and water, non-abrasive or chemically non-
aggressive detergents.
Warranty
Warranty is valid only if the stove is used according to the technical instructions.
Possibilities of heating
The size of the heated space depends on the heating mode and thermal insulation.
Individual heating sources with
Periodical or intermittent heating should be regarded as less favorable or even completely unfavorable.
8,9
kW – set the regulator to 2/3 as shown
8,9
kW of nominal power, depending on the heating conditions, can heat:
under favorable conditions
under less favorable conditions
under unfavorable conditions
160 m³
105 m³
75 m³
19
Publicité
