Suzuki 99134-10L0 Instructions D'installation page 3

NOTICE for installation
• If MIRROR COVER is removed from the mirror and is installed
again, it may fall off because the adhesive strength reduces. Do
the re-installation carefully.
• Don't ride in the rain or wash the motorcycle for 24 hours after
installation of the MIRROR COVER.
• At low temperature (less than 15 degrees), warm the double
sided tape with hair dryer slightly, then install the MIRROR
COVER.
NOTE:
Installation
Illustration and instruction shows the installation for the right side. Please
do the same operation for the left side, too.
Check the installation position
1. Put the Mirror Cover RH① on
the mirror without peeling the
release paper of double sided
tape. Check that the periphery
of the Mirror Cover RH① keeps
the even clearance to the
periphery of the mirror.
NOTE:
Put the Mirror Cover RH ① by slid-
ing it along the diagonal surface as
illustration.
99134-10L00-000
NOTICE
①
GENUINE SUZUKI ACCESSORIES
3/5