Publicité
Les langues disponibles
Les langues disponibles
Dear Customer,
Congratulations on purchasing this product. Please read and follow these instructions, in order to
avoid damaging the item. We do not cover any damages that may arise from improper use of the
item or the disregard of the safety instructions.
Important Safety Instructions
• The product is for household use only.
• Connect the appliance to single-phase AC supply of the voltage specified on the rating label.
• Always turn the product to the OFF position and unplug it from the electrical outlet when not in
use.
• Extreme caution is necessary when the appliance is near children, invalids or elderly person.
• Do not run cord under carpeting and do not cover cord with throw rugs, runners or the like. Ar-
range cord away from traffic area and where it will not be tripped over.
• Do not operate the appliance with a damaged cord or plug, or after the unit malfunctions, has
been dropped, or damaged in any manner.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person to avoid a hazard.
• Use the appliance in a well-ventilated area. While using, distance of no less than 20cm should be
kept away from wall or corner to ensure the air intakes or exhaust openings should not be blocked
unexpectedly. The unit must not be located immediately below or besides a curtain or the likes.
• Do not insert or allow fingers or any other objects into grill to avoid a mechanical danger when in
use. Do not block air intakes or exhaust openings in any manner.
• Use the appliance on flat, dry floor only.
• This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved
• cleaning and user maintenance shall not be made by children without supervision
• Children should be supervised to ensure that they do not play with the appliance.
ASSEMBLE OF BASE
• Be sure to align the four holes in the base with those on the flange of the Outer Tube. Secure the
flange to the bars with the four screws.
• Loosen and remove the Height Adjustment Collar from the top of the Inner Tube. Slide the Base
Decorative Cap down over the assembly.
• Replace the Height Adjustment Collar on top of the Inner Tube. Pull the Inner Tube out from the
Outer Tube to adjust the tube to the desired height and tighten the collar.
• If necessary, slightly loosen the Set Screw by turning it anticlockwise. Slide the Switch Box down
over the Inner Tube and tighten the Set Screw. Make sure the Set Screw is tightly secured.
ASSEMBLE OF BLADE AND GRILLE
• Unscrew the plastic mounting nut from the front of the motor housing by rotating it anticlockwise.
• Fix the front guard and rear guard together with the plastic tightening ring and its screw set pro-
vided.
• Tighten the Rear Grille Mounting Nut clockwise. DO NOT OVERTIGHTEN IT.
• Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the drive pin
that passes through the motor shaft.
• Tighten the blade cap by turning it anticlockwise.
• Fix the front guard and rear guard together with the plastic tightening ring and its screw set pro-
vided.
Assembly & Operation
5
Publicité
