1. INSTALLATION & USE
Use of the lantern:
• The rechargeable lantern is charged by the included charging cable (7) that is stored in the storage compartment (5)
underneath the detachable cover (4). Access the storage compartment by turning the detachable cover counterclockwise.
• Fully charge the lantern before first use by connecting the USB-C male plug (8) to the USB-C power input (3) on the
lantern, and the USB-A male plug (9) to a suitable power source (5V2A).
• When charging the Power button & indicator (1) lights red. When fully charged, it lights green.
If the battery level is below 10% the indicator will light red.
• The lantern is turned on by pressing the power button (1) once.
• Press the power button additional times to toggle through the four different light modes.
Press and hold for stepless dimming of any light mode.
- White light
- Warm yellow light (SMD)
- White light (SMD)
- White light + White light (SMD) - 1 + 3 combined
• All the light modes are dimmable from 10 – 100%. To adjust the strength of a light function,
press and hold the power button on the light function you would like to adjust.
• The lantern is turned off by toggling through the light mode cycles until the end.
• The lantern can be used hanging or standing. The included carabiner (6) can be attached to the metal hanger (1)
and hung in any hanging points, in e.g. your tent or under a tarp.
• Do not stare into the light source.
• Do not modify the product.
2. CLEANING & MAINTENANCE
Lantern can be cleaned with water and a damp rag.
Do not use corrosive liquids to clean the lamp as this might damage the lantern.
3. LIGHT SOURCE
LED Light source and control gear is not replaceable.
This would introduce weak points in the construction, that could reduce the lifetime of the product.
2
4. DISASSEMBLY & DISPOSAL
1) Unscrew and remove the four nuts on top of the lampshade using a
wrench and the two bolts on the base of the grid with a small hex key.
2) Detach the lampshade and base from the metal grid by pulling and
twisting the components until they come loose.
Dispose of plastic components, including polycarbonate lamphouse
and ABS base with detachable cover according to local regulations.
Dispose of metal components, including lampshade, hanger,
screws and grid according to local regulations.
3) Cut wires to allow removal of battery.
Dispose of the batteries according to local regulations.
4) Unscrew screws & cut wires to allow removal of the PCB board.
Dispose of electronics, such as circuit board, light source & electric
wires according to local regulations.
Dispose of remaining components according to local regulations.
5. TECHNICAL DATA
5V
, 3.8W
Input: 5V
, 2A
Battery: 3.7V
, 2500mAh
Degree of protection: The product is water resistant to IPX4
Class 3 appliance
3