Publicité
Les langues disponibles
Les langues disponibles
Deleting number codes
VA/01 - VA/08
+
Ð
RFID
PROG
PROG
F
H
I
J
M1
G
PROG
PROG
beep
beeeep
Put the RFID PROG jumper in the "–"
position. The PROG LED on the power
supply and the
and
slowly F and G.
To delete the number codes relating to
a group, press
, enter an access code
(4 to 8 digits long) associated with the
group, followed by key
If the code is valid, the
constantly on and it is possible to con-
tinue with programming.
Press key
, enter the access code
again and press key
again to confirm
the operation. A long beep will confirm
the procedure was correct.
In the event of an error, this will be
indicated by 3 fast beeps. Repeat the
stage correctly.
To delete all the codes relating to a
group, enter the call code, or press the
call key associated with the group, fol-
I.
lowed by key
If the code is valid, the
constantly on and it is possible to con-
tinue with programming.
Enter the call code again, or press the
call key associated with the group, fol-
J. A long beep will
lowed by key
confirm the procedure was correct.
In each of the two stages of de-
letion any error condition will be sig-
nalled by three fast beeps. Repeat the
stage correctly.
LEDs will flash
H.
LED stays
LED stays
Publicité
