Publicité
Les langues disponibles
Les langues disponibles
Programming door-release codes and relay codes
This procedure lets you associate codes with the relays on the audio module MTMA/01, the video module MTMV/01, or on any
eventual VLS/2.
For example, you can open the front door with a code, or switch on the stairwell lighting with another code.
F
G
Exiting Programming
VA/01
A
H
MTMA/01
MTMV/01
PROG
PROG
I
beep
PROG
M1
PROG
Press the
key and 0, 1, 2 or 3 to iden-
tify the relay (see table).
Press key
and the code to be associ-
ated (from 3 to 5 digits) with the relay.
Press key
again: a beep will confirm
the relay association procedure G.
Key Command
Auxiliary contact
Door release contact
Relay 1 on module VLS/2
Relay 2 on module VLS/2
The door-release and relay code
programming procedure deletes all
the previously programmed codes.
With VA/01
Briefly press the PROG key H.
With MTMA/01-MTMV/01 with-
out VA/01
Briefly press the PROG key on the entry
panel I.
The
LED on the entry panel and the
PROG LED on the power supply go out.
Publicité
