Publicité
Les langues disponibles
Les langues disponibles
PROGRAMMING THE CALL CODES
This programming is available only with audio module MTMA/08 and video module MTMV/08.
Call programming associates a call code with each internal receiver.
Going into Programming
VA/08
>3 s
PROG
A
Programming the call codes
C
D
Exiting Programming
VA/08
>3 s
PROG
E
B
PROG
M3
Briefly press the PROG key E.
The
LED on the entry panel and the PROG LED on the power supply go out.
Press the PROG key until the PROG LED
lights up A.
The
LED will flash to signal entry into
programming B.
Press the door-release
keys and enter the group call code (from
1 to 98) followed by key
code is associated with the internal re-
ceiver or the call key chosen C and D.
Continue, repeating the same opera-
tions for all the other internal receivers.
The operation can only be carried out
from the entry panel with the
To change the entry panel from
which to carry out call programming,
you must press key 1 followed by key
.
beep
and AUX2
: The call
LED off.
Publicité
