Publicité
Les langues disponibles
Les langues disponibles
PROGRAMMING ACCESS CONTROL NUMBER CODES
This procedure lets you associate number codes with a group of users, or remove them, for control of door release in audio
module MTMA/01, MTMA/08 and video module MTMV/01, MTMV/08.
A maximum of 5 number codes can be associated per group.
Adding number codes
VA/01 - VA/08
+
Ð
RFID
PROG
PROG
A
C
D
VA/01 - VA/08
+
M1
Ð
RFID
PROG
PROG
E
M1
B
When programming is completed, place the RFID PROG jumper as shown in figure
E.
PROG
PROG
beep
beeeep
Put the RFID PROG jumper in the "+"
position. The PROG LED on the power
supply and the
and
LEDs will flash
quickly A and B.
Press key
, enter the access code (4
to 8 digits long) followed by key
If the code is valid, the
constantly on and it is possible to
continue with programming. Enter the
group call code, or press the call key
associated with the group, followed by
D.
key
A long beep will confirm the procedure
was correct.
In the event of an error, this will be
indicated by 3 fast beeps. Repeat the
stage correctly.
C.
LED stays
Publicité
