Makita DUB361 Manuel D'instruction page 6

1
► 1 . Button
To remove the long nozzle, press its both buttons and
with the buttons being pressed pull it out.
Installing the shoulder strap
► 1 . Hanger
Pull the hanger out of the tool.
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy
to work with it.
CAUTION:
When you use the tool in combi-
nation of the backpack-type power supply such
as portable power pack, do not use the shoulder
strap included in the tool package.
If you put on the shoulder strap included in the tool
package and the shoulder harness of the back-
pack-type power supply at the same time, removing
the tool or backpack-type power supply is difficult in
case of an emergency, and it may cause an accident
or injury.
OPERATION
Blowing
1
Hold the blower firmly with a hand and perform the
blowing operation by moving it around slowly.
1
When blowing around a building, a big stone or a vehi-
cle, direct the nozzle away from them.
When performing an operation in corner, start from the
corner and then move to wide area.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
Cleaning
From time to time, wipe off the outside of the tool using
a cloth dampened in soapy water.
6 ENGLISH