BLENDER USAGE (CONTINUED)
Turn the Control Dial from (O) to desired speed for constant operation.
3.
When finished, turn the Blender off by returning the Control Dial to (O).
4.
Unplug the Blender before removing the Blender Jar.
IMPORTANT: Allow the Blender to fully stop before removing the Lid, Jar, or pouring out your
blended ingredients.
PULSE /ICE CRUSH FUNCTION USAGE
Your Blender offers a "Pulse/Ice Crush ( )" function with a Soft Start to avoid ingredient
splatter. In this function, the Blender will operate at optimal speed to crush ice. This function
will continue until you release the Control Dial, returning to (O).
Place ingredients or Ice cubes into the Blender Jar.
1.
Firmly secure the Lid with Lid Centre Cap on Blender Jar.
Turn and hold the Control Dial from (O) to ( ) as per desired interval of time. When
2.
finished, release the Control Dial to stop the Blender.
3.
Tamper Accessory
towards the Blade. Then, place the Lid Centre Cap back before resuming blending.
TIP: Use half of standard ice cube tray or 7-8 standard ice cubes at a time for blending. The
Pulse/Ice Crush ( ) function has been optimised to crush and chop ice without adding any
liquid ingredients.
CARE AND CLEANING
IMPORTANT: Allow the appliance to cool completely before putting on or taking off parts, and
before cleaning the appliance.
Empty the Jar. Fill half of the Jar with warm water and add 1 or 2 drops of dish-washing
1.
liquid. Place the Jar on the base. Secure the Lid and Lid Centre Cap.
Run the Blender for 15-20 seconds on speed 3. Remove the Jar, empty contents and rinse
2.
with warm water and dry thoroughly.
NOTE: To avoid damaging the Blender, do not immerse the Blender Base or Cord in water.
Do not use abrasive cleansers or scouring pads to avoid scratching the Blender.
Unplug the Blender before cleaning. Wipe clean the Base, Power Cord and the Gear
3.
Assembly of the Citrus Press with a warm, damp cloth and dry with a soft cloth.
Dishwasher-safe, top rack only: Personal Jar, Small Batch Jar, Lids, Blade Assembly,
4.
Reamer, Tamper
Glass Blender Jar can also be washed in the bottom rack.
ELECTRICAL EQUIPMENT WASTE DISPOSAL
DISPOSAL OF PACKING MATERIAL
The packing material is recyclable and is marked with the recycle symbol
of the packing must therefore be disposed of responsibly and in full compliance with local
authority regulations governing waste disposal.
*Available as an optional accessory.
6
: Remove the Lid Centre Cap only. Stir or press contents down
*
, Juice Container, Pulp Basket, and Lid Centre Cap. Blender Jar and
*
. The various parts