Eaton 9PXMEZ6Ki Installation Et Manuel D'utilisation page 19

All manuals and user guides at all-guides.com
4. Power cables connection
4. Insert the Normal AC source cable through the cable gland.
5. Connect the wires to the Normal AC source (Input) terminal blocks (do not remove the Input Bypass AC
jumper and the UPS Input Bypass jumper inside the UPS I/O cover refer to the UPS User Manual)
4
6. Insert the Output cable through the cable gland.
7. Connect the wires to the Output terminal blocks.
8. Tighten the cable glands.
9. Slide back and secure the ModularEasy I/O cover with the 2 screws.
3
10. Check EBM connected to UPS.
11. Connect the two UPS together with the 9PX parallel cable and lock it.
Use of specific parallel cable is mandatory for first start up and optimal use.
Page 17
614-09354-01_EN