miniland baby digimonitor 3.5 touch Mode D'emploi page 43

You can choose from 10 levels (0-9) by pressing the + or – signs as required.
Moreover, from this menu you can change the power level emitted by the camera, by
choosing between the high/low options. When placed in the HI (HIGH) position, it covers a
distance 300 metros in open country with the original power. When place in the LOW
position, the maximum distance is reduced to approximately 150 metres in open country
and the output power is reduced.
You can also control this feature from the home screen (o). Click on the icon (c) and this
will appear next to the power level emitted (LO, HI). Changes made directly on the home
screen (o) only affect the camera that is picking up the images displayed.
5.3. TROUBLESHOOTING
Problem
No reception on
the monitor
No images are
displayed but sounds
are heard
Only black and white
images are displayed
You cannot hear the
parents's voice in the
baby unit
The camera does
not transmit
All manuals and user guides at all-guides.com
Possible Cause
Camera not turned on
Monitor not turned on
Camera: not plugged in to the
power adapter
Monitor: The power adapter is
not plugged in or the battery is
low (check LED)
The VOX mode or the MD
mode are active
Monitor out or range
Connection lost between the
monitor and a camera already
linked
Low monitor battery power
(check LED)
Check whether the camera is
in night vision/infrared mode
The volumen setting of the
baby unit is too low
The camera is not turned on
Camera: the power adapter is
not plugged in
Solution
Press and hold down button
(II) for 2 seconds
Press and hold down the
power button (6)
Plug in the power adapter
Plug in the power adapter or
charge the battery
To see the monitored area
continuously, disconnect the
VOX or MD mode on the
monitor.
Move the monitor closer
to the camera
Link the camera with the
monitor again
Plug in the power adapter
or charge the battery
To see images in colour,
increase the light level where
the camera is located
Set the volume to the highest
level
Press and hold down button
(II) for 2 seconds
Plug in the power adapter