PAIRING PROCEDURE
After wiring is completed, proceed as follows:
› Ground the alarm harness GREEN wire (Pos. 15);
› Cycle ignition key 4 times within 4 sec. ending the cycle with the key in
the ON position ("
ON-OFF
›The LED will power ON to confirm the system is in learn mode.
› To pair wireless sensors, proceed as follows:
• Magnetic contact: make it transmit (bring contact and magnet together
then move apart);
• Opening detector: press the button.
› A Beep will confirm the device has been paired and the LED will power
OFF 1 sec.
›To exit the procedure, turn ignition key OFF: 2 Bops will confirm the
operation and the LED will power OFF.
› Disconnect and insulate the GREEN wire.
ULTRASONIC CELLS
If installed in the top part of
the windshield internal pillars,
run each wire behind the
respective pillar to avoid
cable-length issues.
ALARM UNIT
Use the supplied double-sided tape
to attach the unit on the left hand
side of the instrument cluster.
BLACK-VIOLET 18-pin connector
Alarm wire
behind the instrument cluster
ORANGE-GREEN (Pos. 18)
LIGHT BLUE-GREY
LIGHT BLUE
ORANGE-BORWN (Pos. 17)
NB: › The alarm does not need to be configured as it is already factory set with
›
To exclude volumetric protection, press the lock button on the vehicle original remote control.
FINAL OPERATIONS: Test the alarm system. If it works properly, remount the dash panels otherwise double check all connections to
make sure they have been made correctly.
The BLUE wire in the alarm harness is a negative trigger output which can be used to connect a pager or a GPS tracker.
"-"
ON-OFF
"-"
ON-OFF
"-"
ON
the LED to the bottom
");
CAN code
Page 2 of 2
STATUS LED
Use the supplied
double-sided tape
to adhesively mount
left-hand corner of
the windshield.
ELECTRICAL CONNECTIONS
WHITE 6-pin connector behind
Alarm wire
the Hazard switch
BLUE
WHITE-YELLOW (Pos. 4)
Alarm wire
RED
RED-WHITE (Pos. 16)
BLACK
BROWN (Pos. 4)
YELLOW
BLACK-BLUE (Pos. 1)
217.
BLACK-VIOLET 16-pin
OBD connector