Gemini 932RE Instructions D'installation page 7

932RE ALARM SYSTEM WITH 7746 SIREN
VOLKSWAGEN CRAFTER & MAN TGE (2018>)
PREPARING FOR INSTALLATION
Remove the Black-Violet OBD
connector from its seat
(located under the driver side
dash).
Connect the sire wires to
Unclip and remove the trim from around the instrument cluster and climate
Remove the 2 Torx 20 screws on the bottom section of the instrument cluster.
Pos. 2 & 6
the alarm unit .
CABLE ROUTING
(GROMMET)
› Attach the siren to the bracket with the
supplied nuts and screws.
› Secure the bracket assembly to the vehicle
with the original 10mm screw (
controls (snap-in clips
Plug the harness connectors into the alarm
Page 1 of 2
FOR
SIREN MOUNTING POSITION
).
corresponding sockets.
).
AC3021 Rev.00