Evolite MOVING BEAM15R Mode D'emploi page 12

Earth must always be connected. Power cables must be approved and comply with the IEC Standard.
Maximum 3 units can be connected in series
 Commissioning
Do not switch on the appliance if it has undergone a major temperature change. Wait for the condensation
to disappear before using the appliance.
When you plug in the mains cable and activate the power switch on the back of the device, it starts up and
displays a welcome message on the front screen:
 Configuration
o Control panel / Menu navigation
Control panel with display.
Access the menu directly by pressing the Menu button, then move through the menus using the UP & DOWN
buttons. Press ENTER to confirm your choices and values.
MENU and DMX PROTOCOL > see end of manual
Selecting DMX mode via cable :
Press MENU then DOWN to access the next menu. Then press ENTER then DOWN to reach the Mode select menu.
Press ENTER then tick the DMX box. Confirm your choice by pressing ENTER.
Press MENU then UP to reach the first menu. Press ENTER to select the Dmx Address menu. Use the UP & DOWN keys
to select the DMX address of the fixture. Press ENTER to confirm your choice. Finally, press MENU twice to return to
the main menu. The fixture is in DMX mode, and if no DMX signal is present, the display will flash. Connect a DMX
cable to the input.
 Care and maintenance
o Cleaning
The outside of the camera should be cleaned regularly. The lenses must be cleaned to ensure optimum brightness. If
the luminaire is installed in a dusty or smoky environment, regular cleaning is very important. Unplug the device
before carrying out any work!
Use a clean, dry cloth.
Moving Beam 15R User's Manual Ver. 1.00
12
Page