HumanTechnik DS2 Mode D'emploi page 9

We would like to congratulate you
on purchasing the »DS-2«. You have
chosen a modern and reliable alarm
clock. Kindly read the instruction ma-
nual carefully in order to use the de-
vice properly and to familiarise your-
self with all its possibilities.
Package contents
Kindly check if all following parts are
included:
- »DS-2«
- 12 volts power supply unit
- Instruction manual
- Warranty card
Should any parts be missing, kindly
contact your specialist dealer or the
manufacturer directly.
Functioning principle
The »DS-2« is an electronic clock with
a digital time display.
It wakes you by flash and/or with an
acoustic signal which is adjustable in
pitch and volume.
Additionally, it can indicate incoming
phone calls by flash and sound sig-
nals.
The following accessories can be
connected to the »AUX« connector of
the alarm clock:
- Vibrating pillow
- Vibration contraption
- Flash module
- Acoustic module
- Telephone cable (optional)
- Microphone cable (optional)
A-3303-0
A-3310-0
A-3320-0
A-3340-0
Setup
Connect the power supply unit to the
12 V power socket of the alarm clock
and plug it into a 230 V power outlet.
Setting the time
To set the time, press the time set
button » « for one second. The
hour digits will start to flash. Set the
desired hour by turning the adjusting
wheel (on the reverse side of the of
the clock) to the left or right.
Press the time set button »
The minute digits will start to flash.
Turn the adjusting wheel to the left or
right to set the desired minutes.
Pressing the time set button »
again will end the time setting proce-
dure and the set time is displayed.
Setting the alarm time
To set the alarm time, press the alarm
time button »
hour digits of the alarm time will start
to flash. Set the desired hour by tur-
ning the adjusting wheel to the left or
right.
Press the alarm time button »
The minute digits of the alarm time will
start to flash. Turn the adjusting wheel
to the left or right to set the desired
minutes.
Pressing the alarm time button »
again will end the alarm time setting
procedure and the set alarm time is
displayed.
« again.
« for one second. The
« again.
English 9
«
«