EN
1
11.9
REMOVE THE HARNESS
1. Open the quick-release fasteners on the chest strap.
2. Loosen the harness straps by lifting the sliding adjusters
and then take off the machine.
In the event of imminent danger, quickly remove the
machine. Release the chest strap before you put the machine
on the ground.
12
OPERATION
Make sure the blower tube is in position before operation.
12.1
START THE MACHINE
1. Pull the trigger (3) to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.
2
3
12.2
STOP THE MACHINE
1. Release the trigger to stop the machine.
Wait until the motor stops after you stop the machine.
2
1
3
WARNING
WARNING
1
NOTE
English
12.3
CRUISE CONTROL LEVER
1. Pull the cruise control lever (2) clockwise to increase the
speed. This will lock the speed at the desired setting.
2. Push the cruise control lever counter clockwise to
decrease the speed.
2
3
If you decrease the speed all the way, the unit will stop and
it is necessary to start the machine again.
12.4
TURBO BUTTON
1. Push the turbo button (1), the machine is at the highest
speed.
2. Release the turbo button, the machine is at the normal
speed.
Using the turbo button drains the battery the fastest. Only
use the turbo button when needed.
12.5
OPERATION TIPS
•
Blow around the outer edge of the unwanted materials to
prevent the unwanted materials from scattering.
•
Use rakes and brooms to clear the unwanted material
before you blow.
•
Make the surfaces wet before you clear the unwanted
material in dusty conditions.
•
Look out for children, pets, open windows, and cleaned
cars during operation.
•
Clean the machine.
•
Discard the unwanted material when you complete work.
13
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
10
1
NOTE
NOTE
CAUTION
CAUTION